Huawei USG6000E Series - Page 532

Before cable connection, labels must be prepared for the cable.
NO TICE
● Make sure that the PC and the USG are connected to the same ground point.
Otherwise, the console port of the USG may be damaged.
● Pay attention to port numbering and make sure that the cable is connected to
the correct port, preventing damage to ports or the device.
Tools
Console cable (prepared by the user)
Procedure
Step 1 Before connecting a console cable, attach temporary labels to both ends of the
cable for identication.
Step 2 Connect the RJ45 connector of the console cable to the console port (RJ45) of the
USG.
Step 3 Connect the DB9 connector of the console cable to the COM port of the
management PC.
Figure 5-14 Connecting a console cable to the USG
Step 4 Remove the temporary labels and attach labels 2 cm away from connectors at
both ends of the console cable.
----End
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 525