● Before replacing a micro SD card, run the sd-card oine command to prevent micro SD
card damage and data loss.
● Do not use too much force; otherwise the micro SD or micro SD card slot might be
damaged.
1. Loosen the screws on the anti-theft board and remove the anti-theft board.
2. Press the micro SD card along the guide rail to loosen the internal card clip.
Then the micro SD card is ejected from the slot. You can then remove the
micro SD card.
3. Place the replaced micro SD card properly.
Figure 6-5 Removing a micro SD card
Step 3 Install the new micro SD card and anti-theft board.
● Note that the micro SD card must be installed with the face with words upwards.
● Do not use too much force; otherwise the micro SD or micro SD card slot might be
damaged.
1. Insert the micro SD along the guide rail to the micro SD card slot.
2. When you hear a click, the micro SD card is in position.
3. Hook the locating hook on the anti-theft board to the locating hole of the
rear panel and tighten the captive screw on the anti-theft board.
HUAWEI USG6000E Series
Hardware Guide 6 Maintaining the Hardware
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 588
To Next Page
Loading...
