Huawei USG6000E Series - Page 598

2. Hold the USG device with both hands and pull it out along the guide rails of
the rear mounting ears. Place the removed USG device in an ESD bag or on
an ESD pad.
Figure 6-7 Removing a device from the cabinet
Step 6 Install the new USG device, connect the cables according to the labels, and then
power on the USG device. For details, see Hardware Installation.
----End
Follow-up Procedure
After replacing the device, pack up all the tools. If the old USG device is faulty,
ll
in the Repair Transmission Sheet and send the faulty device with the Repair
Transmission Sheet to the equipment supplier or the
specied repair service
provider.
HUAWEI USG6000E Series
Hardware Guide 6 Maintaining the Hardware
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 591