Huawei USG6000E Series - Page 63

Port Connector Type Description Available
Components
NOTE
Arrowheads show
the positions of
ports. A down
arrowhead
indicates a port at
the bottom, and
an up arrowhead
indicates a port at
the top.
10GE optical ports
(0 to 1)
SFP+ 2 10GE optical
ports, numbered
from
XGigabitEthernet
0/0/0 to
XGigabitEthernet
0/0/1.
NOTE
In V600R007C20
and later versions,
10GE optical ports
support 1Gbps SFP
Copper Modules
and 1Gbps eSFP
Optical Modules.
By default, the rate
of 10GE optical
ports are 10GE.
You can run the
set device
port-
cong-mode
[ 10ge | ge ]
command to set
the rate of 10GE
optical ports are to
10GE or GE as
required.
●
1Gbps SFP
Copper
Modules
● 1Gbps eSFP
Optical
Modules
● 10Gbps SFP+
Optical
Modules
WAN ports (0 to
1)
RJ45 2 10/100/1000M
autosensing
Ethernet electrical
ports, numbered
from WAN 0/0/0
to WAN 0/0/1.
The device is
connected to the
WAN or cloud
management
center using a
network cable.
Ethernet Cable
HUAWEI USG6000E Series
Hardware Guide 4 Hardware Overview
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 56