Pub. 42004-550A
Elemec3 Console Manual—Version 3.0 Page 96 of 114
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-550A.docx
09/20
Group 1—The currently selected group shows up above the group selection buttons.
Reset this Group—removes all attribute settings configured for the selected group.
Profile—Assign a profile, as required, to SP2 stations with the same group selector switch position.
Profiles provide a method of assigning different values to attributes from what is assigned at the
group and station levels of the hierarchy. To assign a profile to a group, click the PROFILE field label
and select profile one through nine from the dropdown list (see the Profiles Panel section).
Collapsed Parameter Panes—Below the SP2 group information pane are the collapsed parameter panes.
Click the arrow to expand the pane containing parameters needing modification (see the Parameter Panes
section).
Stations Panel
The STATIONS panel permits configuration of attributes for individual SP2/SVS/HUBCOM stations in the
E3 system. Click the STATIONS button, at the top of screen, to access the parameter panes at the station
level. The STATION VIEW PANEL works with the STATION LIST to open the properties of individual
stations in the configuration.
Figure 104. Station View Panel (No Station Selected)
Select a Station—Select stations from the station view list (see the Find Station and Station List Utility
section for the functionality of the STATION LIST utility). The configuration properties for the station
appear in the STATION VIEW panel after a station is selected.
To Next Page
Loading...
