Main Balance Screen – Servoing To Position
If servoing is enabled in Setup, the balancer will servo
either the inner or outer place weight position to top
dead-center. To servo to the next position, the operator
can either touch the “Servo” button or touch the
corresponding weight amount.
Main Balance Screen – Force Match® Buttons
Touching the Force Match® button expands a set of
button options. The load roller can be disabled/enabled.
The operator can change the Force Match® limits. The
“Show Savings” button can show detailed views of the
cost savings from Force Match® balancing. And nally,
the operator can select one of three Force Match®
procedures: Force Matching® and HD Elite80 Matching.
Display of historical data is also available.
Main Balance Screen – SmartWeight® Buttons
Touching the SmartWeight® button expands a set
of button options. SmartWeight® can be disabled or
enabled, Performance Mode can be disabled or enabled
and Weight savings can be viewed.
HD Elite Wheel Balancer
Page 13 of 51
To Next Page
Loading...
