Hunter HD Elite - Page 18

WARNING
DO NOT pry or hammer stuck
pins from adjustable ange
plate.
The correct ange adaptor setup is
determined by the following:
Measure and set the bolt circle diameter and
number of studs to use against the lug holes.
Set the number of lugholes as follows:
• A three-lug wheel uses three studs.
• A four-lug wheel uses four studs.
• A ve-lug wheel uses ve studs.
• A six-lug wheel uses three studs.
• A seven-lug wheel uses seven studs.
• An eight-lug wheel uses four studs.
NOTICE
For Ford 7 X 150 mm lug pattern, align the index pin
to the 150 mm mark and insert the remaining six pins,
20-3689-1, into the #7 slots. Insert the end of pin
through the 3/16 inch holes in the guide plate.
Choose the correct taper design of ange studs to t the wheel lug
seats. The mounting area of the ange stud must match the design of
the wheel’s lughole seat or depression.
The ange plate must be able to apply pressure to the center of the
wheel while maintaining perpendicularity to the shaft.
NOTICE
If the lug seats are unevenly machined or worn, an
optional universal ange adaptor with compressible
studs or bolt on lugs may be used to more accurately
mount the wheel with the collet.
6. Choose the type of pin sleeve that best ts the lugholes in the wheel. 3/4 inch diameter conical pin sleeves,
106-145-2, will t smaller lugholes.
1-inch diameter conical pin sleeves, 106-143-2, will t larger lugholes.
7/8-inch diameter spherical pin sleeves, 106-144-2, will t lugholes of many German autos.
NOTICE
If the installation of pin sleeve is dicult or not secure, clean inside of pin sleeves and pin assemblies,
then apply light machine oil to mating surfaces.
7. Push the pin sleeve to the end of pin assemblies
Use Adjustable Flange Plate to Mount Wheel to Balancer as follows:
1. Determine the cone (or collet) that best ts the
center bore of the wheel to be balanced. Choose
the cone the contacts the wheel nearest to the
center of the cone.
2. Place the wheel-mounting cone on the spindle
against the spring plate.
3. With the wheel on the garage oor, adjust the
ange plate to match pins with the lug pattern of
the wheel. Adjust the diameter of the pin pattern on
the ange plate by turning the guide plate against
the hub plate.
4. Tighten the thumbscrew located on the guide side
of the ange plate to lock the guide plate and pin
positions.
HD Elite Wheel Balancer
Page 18 of 51