WARNING
The pin pattern on the ange plate must be adjusted to the diameter of the lug pattern of the wheel, prior to
mounting the ange plate to the balancer. The pins will NOT self adjust as the wing nut is tightened. If the pins
are not properly adjusted to the lug pattern, the pin tabs, adjustable ange plate or wheel may be damaged.
5. Mount the wheel with the inner rim facing the balancer and centered on the cone.
6. Mount the adjustable ange plate to spindle with pins matched to lug holes.
7. Install the pressure ring (or clamping cup) and wing nut on the spindle shaft against the adjustable ange plate.
8. Secure the entire assembly by rmly tightening the wing nut.
Disassemble Flange Plate Set-Up as follows:
1. Pull pin sleeves from the end of the pin assemblies.
2. Remove the pin assemblies from the numbered slots by pushing down and rotating each pin a quarter turn. Leave the
index pin on the adjustable ange plate.
3. Place pin sleeves and pin assemblies in the storage bin located on side of balancer.
WARNING
An expandable collet should NOT be used with the HDElite due to the amount of force applied by the load
roller.
Using the Pressure Ring and Spacers
Pressure Ring
The pressure ring clips on to the wing nut. It is used in
lieu of the clamping cup. It may also be used in place of
a clamping cup if space is limited between the wheel and
the end of the spindle.
The pressure ring should be used to prevent the wing nut
from directly contacting an adaptor or a collet.
It will act as a bearing to enable higher
clamping forces.
Hub Ring Spacers
These spacers are designed to build a larger
pocket when using extra large collets. It also
provides a location for the centering pins
found on some dual wheel congurations.
HD Elite Wheel Balancer
Page 19 of 51
To Next Page
Loading...
