E.12 Part. N. 8000 H0364 (09-2008)
GENERAL OPERATIONS
7) Remove the cap (1) from the spark plug. Remove the clamp (2) and detach
the hose (3) from the cylinder head cover. On the L.H. side, using a 6 mm wrench,
remove the rear transmission sprocket cover screws (4) and, using a 6 mm
Allen wrench, remove the screws (5) that fasten guide-chain plate.
Using a 8 mm wrench, remove the three screws (6) that fasten the clutch control
on the engine and eliminate the remaining fluid from the hose.
TE-SMR-TXC: detach the electrical connections from the starting motor [use a 8
mm wrench to remove the ground cable (8) and a 10 mm wrench to remove the
nut under the rubber cap (9)].
Remove the clutch hose-alternator cable connecting clamps (10). Detach the
alternator connector (11) (alternator cable-main wiring harness).
3
2
4
5
10
10
1
9
6
11
11
8
6
To Next Page
Loading...
