Husqvarna T540 XP - STARTING AND STOPPING; Starting and stopping; Cold engine; Warm engine

English – 21
Safety equipment
Fig 17
6.4 Assembling the muffler
1
Assemble the mufer and align the gasket in place.
See Figure 17. Insert a screwdriver or the like in one
of the holes to make it easier to position the gasket.
2
Screw the mufer in place. Assemble the oil pump
cover, the centrifugal clutch and vibration element.
3
Make sure the bushing is tted on the inside as
outlined in gure 18a before tting the front hand
guard to the chain saw.
4
Fit the front hand guard. Press down the spring
using a suitable tool and then press the kickback
guard into its bracket. See gure 18b. Tighten the
screw. Tightening torque of 8-10 Nm.
5
Fit the bar, the saw chain and the clutch cover.
Warm up the saw for at least 1 minute and
retighten the mufer screws.
Cleaning and checking
• Clean and check all components carefully.
Parts must be replaced if cracked or show
signs of other defects.
• Always use original spare parts. The spark
arrestor mesh is best cleaned with a wire brush.
The mesh must be replaced if it is damaged.
The saw will overheat if the mesh is clogged
resulting in damage to the cylinder.
• Never use a saw with a mufer in bad condition.
Fig 16
Fig 18b
Fig 18a