English – 25
Safety equipment
2
Fit the throttle and throttle lockout to their
attachments in the handle and make sure that
the hooks end up inside the handle as outlined in
Figure 30. Replace the recoil spring in the throttle
lockout.
6.10 Assembling the throttle lockout,
throttle and spring
1
Hook the throttle cable and the recoil spring in their
attachments in the throttle as outlined in Figure 29.
Fig 29
3
Fit the handle half and tighten the screws. Press
down the stop switch in its holder. See Figure 31.
4
Then t the front hand guard (See section 3, “As-
sembling the mufer”), the bar, the saw chain and
the clutch cover.
Cleaning and checking
• Clean and check carefully all components.
Parts must be replaced if cracked or show
signs of other defects. Always use original
spare parts.
• Check that the recoil spring is intact and
retains all its tension.
Fig 28
Fig 30
Fig 31
To Next Page
Loading...
