18 – English
6.2 Assembling the chain brake
1
Place the knee joint with the tted brake band in
its groove in the clutch cover as outlined in Figure
7. The space for the spring in the cover must be
lubricated with grease.
Safety equipment
Fig 5
Fig 8
Fig 6
5
Remove the knee joint with the attached brake
band from its attachment in the clutch cover.
Cleaning and checking
• Clean and check carefully all components.
Parts must be replaced if cracked or show
signs of other defects. Always use original
spare parts.
• Measure the thickness of the chain brake
band. It must not be less than 0.6 mm at any
point. See gure 5.
• Lubricate the knee joint with grease.
• If necessary, dismantle the chain adjuster and
check the tension block (A), worm shaft (B)
and worm shaft (C). See Figure 6. Lubricate all
components with grease.
Fig 7
min 0,6 mm
2
Make sure the brake band is tted to the hooks in
the clutch cover. See Figure 8.
To Next Page
Loading...
