English – 47
Repair instructions
7.14 Dismantling the intake system
Dismantle the following:
• Clutch cover.
• Front hand guard.
• Air lter cover.
• Air lter.
• Air lter holder.
• Carburettor.
1
Loosen the screws holding the fuel pump
attachment and the air valve. Remove the throttle
cable from its attachment. Then loosen the screws
holding the bottom of the carburettor. See gure 55.
Fig 55
Fig 56
2
Loosen the vibration elements as outlined in Figure
56.
Fig 57
3
Dismantle the starter. Loosen the screw holding
the vibration element in the handle. See gure 57.
4
Remove the spark plug cap and the spark plug,
and move the tank unit to one side.
Fig 58
5
Remove the air duct bellows from the bottom of the
carburettor by unsnapping it from its attachments.
See Figures 58 and 59. Then remove the inlet
bellows and loosen the impulse hose from its
attachment at the back of the carburettor bottom.
Remove the carburettor bottom.
Fig 59
To Next Page
Loading...
