Husqvarna T540 XP - MAINTENANCE; Air filter; Spark plug

English – 35
Repair instructions
7.8 Assembling the ignition module and
the flywheel
1
Fit the ywheel onto the crankshaft journal. Turn
the ywheel until the key ts into the key slot on
the axle. See gure 19 Tighten the nut and screw
the pawls back on the ywheel.
The ignition module must be tted as follows:
2
Pull the ignition module cabling through the
crankcase as outlined in Figure 20 and place the
ignition module in position.
3
Turn the ywheel so that the magnets are aligned
with the ignition module and place the plastic feeler
gauge, 521 03 13-01, between the lugs on the
ignition module and the ywheel magnets. See
Figure 21.
4
Tighten the screws for the ignition module and
remove the plastic feeler gauge. See Figure 21.
5
Fasten the ignition module cabling to the
contact strips in the handle part. See Figure 14
”Dismantling the ignition module and ywheel.”
6
Fit the spark plug cap on the ignition cable.
Note! When tting a new ignition module a hole
has to be made in the ignition cable for the spring.
Use the assembly pliers, 502 50 06-01. See Figure
22.
7
Pull the ignition cable through the tank unit to the
spark plug. See Figure 12, ”Dismantling the ignition
module and ywheel.”
8
Then t the:
• Air lter cover.
•
Vibration element.
•
Oil pump cover and centrifugal clutch.
•
Air guide rail and starter.
•
Handle half and stop switch.
• Front hand guard. See section 3, “Assembling
the mufer”.
•
Guide bar and saw chain.
•
Clutch cover
Fig 20
0,3 mm.
Fig 21
Fig 19
Fig 22