22 – English
Safety equipment
6.5B Replacing the chain catcher
A worn chain catcher must always be replaced with
a new one.
1
Release the brake by moving the kickback guard
backwards. Loosen the bar nut and remove the
clutch cover, saw chain and bar.
2
Loosen the screw and replace the chain catcher
with a new one as shown in Figure 19c. Tightening
torque 8-10 Nm.
Fig 19c
Fig 19a
Fig 19b
6.5A Assembling the spike bumper
The spike bumper is not tted at the time of deliv-
ery. When a spike bumper is tted the rst time,
the washer tted above the limiter cap must be
removed. See Figure 19a.
1
Release the brake by moving the kickback guard
backwards. Loosen the bar nut and remove the
clutch cover, saw chain and bar.
2
Loosen the screws and remove the washer and
chain catcher. See Figure 19a.
3
Fit the spike bumper as outlined in Figure 19b.
Then t the saw chain, the bar and the clutch
cover.
To Next Page
Loading...
