English – 37
Repair instructions
7.10 Assembling the centrifugal clutch
1
Hook the springs into the clutch shoes using a
pliers. See Figure 27.
2
Screw in the clutch (anti-clockwise) until it stops.
Then tighten the clutch using tool 502 54 16-02
and a suitable socket spanner. Tightening torque of
20 Nm. See Figure 24 ”Dismantling the centrifugal
clutch”.
3
Remove the piston stop and t the spark plug and
spark plug cap. Tightening torque for the spark
plug is 18-20 Nm.
4
Assemble the air lter cover, saw bar, saw chain
and clutch cover.
Fig 27
7.11 Dismantling the oil pump and
screen
1
Empty and clean the oil tank.
Dismantle the centrifugal clutch. See the
”Dismantling the centrifugal clutch” chapter.
Dismantle the clutch drum and the needle bearing.
See Figure 28.
2
Loosen the screws as outlined in Figure 29 and
remove the oil pump cover.
Fig 29
3
Remove the chain guide plate (A) and the pump
drive wheel (D). See Figure 30.
Fig 31
4
Loosen the screws for the oil pump as outlined
in Figure 31 and remove it together with the oil
pressure hose.
Fig 28
Fig 30
To Next Page
Loading...
