English – 23
6.8 Resistance test - stop function
1
Remove the handle half. See Section 2 and
Figure 24 in the ”Dismantling the throttle lockout,
throttle and spring” chapter.
Fig 23
Clean the contact areas and check the resistance
as follows:
Test the resistance by connecting a multimeter to
the ignition switch’s cabling (black and blue cable).
NOTE! The power switch must be held in the
“Stop” position to get the correct reading.
See Figure 23.
The resistance must not exceed 0.2 Ohm with
the stop switch is placed in the ”Stop” position.
6.6 Dismantling the stop switch
1
Dismantle the start/stop switch with a screwdriver.
See Figure 20.
2
Check that the stop switch is intact.
Cleaning and checking
•
Clean and check carefully all components.
Parts must be replaced if cracked or show
signs of other defects. Always use original
spare parts.
Fig 20
6.7 Assembling the stop switch
1
Fit the cables. See Figure 21
2
Press the stop switch into its holder as outlined in
Figure 22.
Fig 21
Fig 22
Safety equipment
To Next Page
Loading...
