English – 33
7.7 Dismantling the ignition module
and flywheel
1
Dismantle the following:
• Starter and air guide rail.
•
Clutch cover.
•
Guide bar and saw chain.
•
Front hand guard.
•
Air lter cover and air lter.
•
Centrifugal clutch and oil pump cover.
Fig 11
2
Loosen the vibration elements as outlined in gure 11
4
Grip the spring with a pliers and pull the ignition
cable out through the spark plug cap. see Figure 13.
Pour a little soap and water in the spark plug cap
to facilitate this step.
Fig 15a
5
Loosen the handle half and remove the throttle
and the throttle lockout. Split the contact strips as
outlined in Figure 14.
Fig 13
3
Unhook the spark plug cap and carefully lift the tank
unit to create enough space to get the ignition cable
and spark plug cap through. See Figure 12.
6
Loosen the screws as outlined in Figure 15a and
remove the ignition module.
Fig 12
Fig 14
Repair instructions
To Next Page
Loading...
