34 – English
Cleaning and checking
• Clean all parts, especially the tapers on the
ywheel and axle.
•
Check the ywheel for cracks and any other
damage.
Fig 15b
7
Knock out a few of the pins in the tool if it does
not match up with the ywheel. Press against the
ywheel while the ywheel nut is loosened using a
suitable socket spanner. See gure 16.
Fig 16
8
Unscrew the pawls as outlined in gure 17.
9
Screw the mandrel on the crank shaft journal.
Screw in until 1-2 threads are left on the ywheel.
Knock on the mandrel with a suitable metal
hammer while at the same time pulling the ywheel
outward until the it comes off the shaft. See Figure
18. Then remove the mandrel.
Fig 17
Fig 18
6
Pull the ignition module cables through the opening
in the crankcase. See Figure 15b.
Repair instructions
To Next Page
Loading...
