English – 61
Repair instructions
Fig 94
7.29 Replacing the bar bolt
Replacing a bar bolt with intact crankcase
1
Empty the chain oil tank.
2
Knock in the old bar bolt from the outside so that it
ends up in the chain oil tank.
3
Remove the bar bolt from the chain oil tank.
4
Attach a steel wire to the thread of the new bar
bolt, thread the steel wire through the chain oil tank
and out through the bar bolt opening in the crank-
case. See Figure 94.
5
Pull on the steel wire so that the bar bolt protrudes
from its opening. Make sure the head of the bar
bolt nishes up in its groove in the crankcase. The
bar bolt may have to turned.
6
Pull out the bar bolt with a nut. Insert a spacer
between the nut and the crankcase. See Figure 94.
7
Fill with chain oil.
To Next Page
Loading...
