Husqvarna T540 XP - Page 60

60 – English
NOTE!
Ensure gasket leftovers does not fall into
the crankcase.
x5
x1
5
Place the guide pin in the crankcase half of the
ywheel and t a new gasket. Fit the 577 70 16-01
assembling tool to the crankshaft journal. See
Figure 92.
6
Put the crankshaft in position and t the other
crankcase half. Screw in the six screws. Tighten
them alternately. Tightening torque of 7-9 Nm.
Note! Remove the protective sleeve from the
crankshaft journal after assembling the crankcase
halves.
Assemble the following parts:
• Cylinder.
• Oil pump.
• Intake system and cylinder cover.
• Tank unit.
• Carburettor.
• Ignition module.
• Flywheel.
• Starter.
• Centrifugal clutch.
• Front hand guard. See section 3, “Assembling
the mufer”.
• Guide bar and saw chain.
• Clutch cover.
Fig 92
Fig 93
7
Cut off any excess gasket on the cylinder side. See
Figure 93.
Repair instructions