Husqvarna T540 XP - Assembling the Tank Unit; Dismantling the Tank Unit

50 – English
7.16 Dismantling the tank unit
WARNING!
The fuel used for the chain saw has
the following hazardous properties:
1.
The liquid and its fumes are
poisonous.
2. Can cause skin irritation.
3. Is very flammable.
1
When dismantling the tank unit, see the ”Dismantling
the intake system” chapter (points 1-4).
2
Dismantle the handle half and remove the throttle
and the throttle lockout. See the ”Dismantling the
throttle lockout, throttle and spring” chapter.
3
Split the cabling to the ignition module and
unscrew the screws holding the cable guard as
outlined in Figure 65.
4
Remove the cabling and the throttle cable from its
groove in the handle and remove the tank unit.
Fig 65
7.17 Assembling the tank unit
1
Fit the tank unit over the saw body and slide the
cabling and the throttle cable into the handle.
2
Place the cabling in the cable groove in the handle
as outlined in Figure 66.
3
Fit the cabling to the ignition module and screw the
cable guard back in place as outlined in Figure 66.
4
Assemble the throttle and throttle lockout. See
the ”Assembling the throttle lockout, throttle and
spring” chapter.
5
Assemble the fuel pump, the air valve and throttle
cable as outlined in Figure 55, ”Assembling the
intake system”.
Fig 66
Then assemble the following:
• Carburettor.
•
Air lter holder.
•
Air lter.
•
Air lter cover.
•
Clutch cover
•
Starter.
Repair instructions