38 – English
Cleaning and checking
• Clean and check all parts carefully. Parts must
be replaced if cracked or showing signs of
other defects. Always use original spare parts.
• Lubricate all moving parts with saw chain oil.
7.12 Assembling the oil pump and
screen
1
Lower the oil lter in place and ret the oil pump
and the oil pressure hose as outlined in Figure 31.
Tighten the screws, using a tightening torque of
3-4 Nm.
2
Assemble the pump drive wheel, chain guide plate,
needle bearing, clutch drum and centrifugal clutch.
See Figures 30, 29 and 28 for ”Dismantling the oil
pump and screen”.
3
Adjust the oil pump.
The adjuster screw for the oil pump is located at
the bottom of the saw. See Figure 33.
4
Fit the bar, the saw chain and the clutch cover.
Fig 33
Fig 32
WARNING!
Insufficient lubrication of the chain
can result in chain breakage, which
can cause serious personal injury.
Repair instructions
To Next Page
Loading...
