Husqvarna T540 XP - Page 46

46 – English
Assemble on the saw
1
Assemble the carburettor and secure the suction
hose (K), the throttle cable (M) and the fuel hose
(N). Hook the link arm (P) to the air valve and
connect the connector. See gure 51.
Fig 52
Fig 53
3
Fit the lter holder over the carburettor and screw
the screws back in place. Secure the suction hose
(K) and the bleeding hose (L) to their attachments
in the lter holder. See gure 54.
K
M
P
N
L
2
Fasten the AutoTune service connector to its at-
tachment on the back of the lter holder (T540 XP).
See gure 53.
See gure 53b regarding T540 XP II
Fig 54
Assemble the following parts:
• Air lter.
• Air lter cover.
Repair instructions
Fig 53b
T540 XP
T540 XP II