48 – English
Cleaning and checking
Clean and check all parts carefully. Parts must be
replaced if cracked or show signs of other defects.
Always use original spare parts.
Fig 62
Fig 60
Fig 61
Fig 63
6
Loosen the two lower screws holding the oil pump
cover. See gure 60.
7
Loosen the four screws holding the intake system.
See Figure 61.
8
Loosen the oil pump cover from its groove and
carefully remove the cylinder cover with the intake
system. See Figure 63.
8
The intake plate is fastened to the cylinder cover
using the hooks (one on each side). See Figure 62.
Repair instructions
To Next Page
Loading...
