Husqvarna T540 XP - Page 41

English – 41
Repair instructions
Dismantling the carburettor
1
Dismantle the air lter and air lter cover.
2
Loosen suction hose (K) and bleeding hose (L)
from their respective attachments in the lter
holder. Then unscrew the screws and lift out the
lter holder. See Figure 41.
L
4
Use a small at screwdriver to unsnap the
connector. Then loosen the suction hose (K), the
throttle cable (M) and the fuel hose (N) from the
carburettor. Unhook the link arm (P) from the air
valve. See Figure 43.
Fig 42
Fig 43
3
Remove the AutoTune service connector from its
attachment on the back of the lter holder
(T540 XP). See Figure 42
See gure 42B regarding T540 XP II.
Fig 41
Fig 42B
T540 XP
T540 XP II