44 – English
5. Check using a ruler or the like that the lever
arm is level with the cover. The lever arm can
be bent if necessary. See Figure 49.
Fig 48
Fig 47
Assembling the carburettor
Observe cleanliness when assembling the
carburettor. The slightest contamination can cause
malfunctions.
1. If throttle and choke valves with shafts, lever
arms and springs have been removed, these
must be assembled. The springs are tightened
1-2 turns. Lubricate the shaft bearings using a
light oil.
2.
Fit the fuel screen (V) by using the handle of a
small screwdriver.
3.
Assemble membrane (W) with gasket and
screw tight the pump cover (X). See Figure 47.
4. Fit the needle valve (U) with lever arm (T),
axle and spring. Screw in the screw (S).
See Figure 48.
Fig 49
Repair instructions
To Next Page
Loading...
