Huvitz Excelon XD - Page 105

104 Excelon XD/XQ Operator’s Manual
6.3.10.2 Drill Hole Diameter Adjustment
Load “Drill Hole Dia Adj” data in the Job menu and then start processing.
Drill Hole Diameter Adjustment Pattern
Find a hole that Ø 2.0mm standard pin passes through softly.
If the matched hole found, adjust “Drill Hole Diameter Adj” value according to the
following table.
Matched hole
Compensation value
⑤
Current value - 0.10
④
Current value - 0.05
③
Keep the current value
②
Current value + 0.05
①
Current value + 0.10
If there is no matched hole, adjust “Drill Hole Diameter Adj” value manually.
Hole diameter > Ø 2.0mm : decrease the compensation value
Hole diameter < Ø 2.0mm : increase the compensation value
No
Diameter
(mm)
Tilting
(°)
①
1.90
Auto
②
1.95
Auto
③
2.00
Auto
④
2.05
Auto
⑤
2.10
Auto
①
②
③
④
⑤