132
7. Alarm List
Alarm
No.
Alarm Picture Cause Action
19
Pushrod can not go back while
trying to push hexagonal bar to part
off position.
There is a problem
inside of the spindle, so
pushrod can not go
back.
Check inside of the spindle.
20
Somebody turned auto/manual
switch while auto running.
Somebody changed bar
feeder working mode
and stopped auto
running.
Select auto mode and start
auto cycle again.
21
CNC working mode changed and
now not auto mode when bar feeder
auto cycle.
CNC working mode
changed and stopped
auto cycle.
Start auto cycle again.
To Next Page
Loading...
