148
8. Warning List
Warning
No.
Warning Picture Cause Action
22
Turret comes to part off
position by time controlled
by CNC lathe, not
controlled by B/F.
Hence, part off with turret
function can’t used under
eject remnant by new bar.
Select eject remnant
function be pushrod ( on
3.11.2 )
23
PLC battery voltage low.
After using PLC for a long
period, the battery of PLC
may degenerate, will
cause decreasing of
output voltage, from 3.6 V
normally to 3.0 V or under.
The warning will be given
when B/F power on every
time. Please replace the
battery of application
within 60 days. Otherwise,
the datum can’t be stored
in internal memory.
-When alarm occurs,
press < NEXT> button
to cancel
-Replace battery
Note: Replacing battery
has to be done within 3
minutes.
24
No preset data.
To Next Page
Loading...