Connect for Communication
XPR300 Instruction Manual 809480 191
Other
On this screen you can view the software versions and monitor the status of the wireless
connection. From this screen, you can also access the Configure, Connect, and Update
commands.
The XPR web interface shows different fields for different XPR models.
The screen shown is for reference only.
Configure – On this screen you can change the connection name, limited AP password, limited AP
IP address, or the setup password
You cannot use special characters in any of the fields on this screen.
The connection name must be less than 32 characters long.
Passwords must be between 8 and 20 characters long.
Passwords are case sensitive.
Connect – On this screen you can change your client settings and connect to other networks. For
more information on how to do this, refer to Use network mode to connect on page 169.
Update – On this screen you can update the web interface and firmware.
To Next Page
Loading...
Need help?
General
