Hypertherm XPR170 - Measure the Line Voltage between the Terminals Inside the Plasma Power Supply

Diagnostics and Troubleshooting
8
XPR170 Instruction Manual 810060 265
Diagnostic codes
How to diagnose and troubleshoot diagnostic codes
Use the Corrective action column of Table 36 on page 267 to respond to the diagnostic codes that
show on the CNC or XPR web interface.
Diagnostic codes can include the following abbreviations:
GCC – Gas connect console
CAN – Controller area network
TCC – Torch connect console
t/o – Time out
HF – High frequency
IGBT – Insulated-gate bipolar transistor
Ch1 – Chopper
DC – Direct current, current
Ind – Inductor
MagFan – Magnetics fan
HxFan – Heat exchanger fan