XPR170 Instruction Manual 810060 235
Maintenance
Overview
Hypertherm cutting systems can operate in harsh conditions for many years. To maintain cutting
system performance, minimize operating costs, and lengthen cutting system life, it is important to
follow all maintenance procedures and schedules.
If you have questions about how to maintain your cutting system, contact
your cutting machine supplier or regional Hypertherm Technical Service
team. You can find contact information for your regional office at
www.hypertherm.com on the “Contact us” page.
This section of the manual describes maintenance steps that you must do daily, before system
operation.
For instructions about preventive maintenance (such as weekly, monthly, and yearly tasks)
refer to the XPR Preventative Maintenance Program (PMP) Instruction Manual (809490).
For recommendations about how to diagnose and troubleshoot performance issues, refer to
Diagnostics and Troubleshooting on page 257.
For printed circuit board (PCB) drawings and LED locations, refer to PCB information on
page 341.
Refer to Table 32 on page 236 for a list of preventive maintenance steps.
The XPR Preventative Maintenance Program (PMP) Instruction Manual
(809490) explains how to do them.
Usually, operators can do the daily, weekly, and bi-monthly tasks. Usually
qualified maintenance personnel are needed for monthly, every-6-month,
and yearly tasks.
To Next Page
Loading...
