Hypertherm XPR170 - Gas Connect Console

Installation
3
XPR170 Instruction Manual 810060 85
Gas connect console
All 3 gas connect consoles (Core, VWI, and OptiMix) have 3 mounting holes on the bottom panel.
For mounting dimensions, refer to Figure 1 on page 85 and Figure 2 on page 86. If you have
questions about when or how to use the mounting holes, contact your cutting machine supplier or
regional Hypertherm Technical Service team.
Figure 1 – Mounting dimensions for the Core and VWI gas connect consoles
26.98 cm
(10.63 in.)
1.27 cm
(0.50 in.)
Gas inlet side
of gas
connect
console
Gas inlet side of gas connect console (Core)
19.69 cm
(7.75 in.)
6.48 mm
(0.26 in.)
Never position the gas connect console at an angle
Gas outlet side of
gas connect
console