Qualifications and Requirements
XPR300 Instruction Manual 809480 65
CNC requirements
Remote on-off switch
The CNC must have a remote on-off switch
Adjustable settings
The CNC must allow the adjustment of the following settings:
Current setpoint
Plasma cutflow
Shield cutflow
Gas mixing setpoints
Display settings
The CNC must show the following data:
Plasma gas type
Shield gas type
Process ID selected
System diagnostic codes
Gas connect console firmware version
Plasma power supply firmware version
The CNC must show the following data in real time to troubleshoot and diagnose system operation:
Chopper current
Work lead current
System status codes
Chopper temperature
Transformer temperature
Coolant temperature
Coolant flow
Process gas pressures
Fan speeds
To Next Page
Loading...
Need help?
General
