List of Tables
22 810060 Instruction Manual XPR170
Table 26 – Pinout for J19 on the discrete cable ....................................................................................... 154
Table 27 – Pinout for J2 on the VDC3 board ............................................................................................ 163
Table 28 – Available non-ferrous processes by gas connect console type and gas type.............. 218
Table 29 – Process recommendations for cut quality, based on metal thickness and type ........... 218
Table 30 – Process category options and expected quality-speed results
for ferrous (mild steel) processes.................................................................................................................. 226
Table 31 – Process category options and expected quality-speed results
for non-ferrous processes............................................................................................................................... 227
Table 32 – Inspection, preventive maintenance, and cleaning tasks.................................................... 236
Table 33 – Inspection tasks for consumables ........................................................................................... 241
Table 34 – PCB names and locations......................................................................................................... 262
Table 35 – Diagnostic codes in the web interface................................................................................... 266
Table 36 – Diagnostic codes......................................................................................................................... 267
Table 37 – Minimum and maximum ohmic resistance values for thermistors..................................... 315
Table 38 – Minimum and maximum ohmic resistance values for thermistors..................................... 320
Table 39 – Minimum and maximum ohmic resistance values for thermistors..................................... 337
To Next Page
Loading...
