Hypertherm XPR170 - Page 335

Diagnostics and Troubleshooting
8
XPR170 Instruction Manual 810060 335
4. Locate the pilot arc relay (CR 1) and remove the dust cover .
5. Have a second person close (push in) the contact on the pilot arc relay.
6. Measure the ohms between the nozzle and the workpiece. Less than 3 ohms is good. A value
greater than 3 ohms indicates a faulty connection between the torch and ignition console, or
between the ignition console and the power supply, or between the power supply work lead and
workpiece.
4
5
4
5
(+)
21
(-)
22