Function
Functio n Description
Op eration
AUX operation The device connected
to the AUX terminal
of the camera is set to
the Open/Closed
state.
Select "AUX" as the operation mode and click the [
▼
] button to
select the AUX terminal number.
●
Click the [Open] button to open the AUX terminal of the
camera.
●
Click the [Close] button to close the AUX terminal of the
camera.
Note
AUX terminal number selection is valid only for WJ-GXE500. For
cameras other than WJ-GXE500, only Open/Close operation is
possible.
Wiper
operation
Operate the
washers/wipers on the
WV-SUD638.
Select "Wiper" as the operating mode, click the [
▼
] button, select
the following camera wiper functions, and click the [Start] or
[End] button.
●
High-speed: Continuous wiping operation. (once every 4
seconds)
●
Low-speed: Continuous wiping operation (once every 8
seconds)
●
Temporary control: Performs 5 wiping operations at high
speed (once every 4 seconds).
●
Washer: Performs the specified washer/wiper operation.
Note
●
The following operations cannot be performed while the
washer is in operation.
・
"Wiper" function - [Start] and [End] operations
・
Pan, tilt, zoom, and focus control
・
"Auto mode" - [Start] operation
・
"Preset" - [Move] operation
●
Washer operation setting is required on the camera side. For
more information, refer to the Operating Instructions of
WV-SUD638.
Active
ClearSight
Activates the Active
ClearSight function.
Select "Active ClearSight" as the operation mode and click the
[START] button.
[Operation via PC web browser]
341
To Next Page
Loading...
Need help?
General
