●
Depending on the position of the area box, it is sometimes corrected
slightly after the transfer settings.
If the area box is too small, the area number will not be displayed correctly.
[Model] [Error information]
Refer to the following section.
☞
Camera setup [Camera]
[Setup VMD area]
Click the top left corner and bottom right corner of the square on the screen, set the
specified position as area 1, and display the area box. Area will be set in numerical order
starting form area number 1. When the [Delete] button is clicked, the designated area will
be deleted.
[Status]
When the motion detection area is set to Off, the status of the area will be switched to
"Off".
[Detection sensitivity]
Set the sensitivity when moving within the area to be detected.
1 (low) ~ 15 (high)
[Transmission] button
Transmit the setting of the "VMD alarm" to the camera. Once transmission is completed
and the setting has been applied to the camera, "OK" will be
displayed in the "Results" field. When the Error information is not displayed as "-", it cannot
be transferred to the camera.
[Back] button
Click the button after completing the settings. The screen returns to the [Camera setup]
tab.
Set schedule [Schedule 1 to Schedule 4]
Click the [Setting
＞
] button for "Schedule 1" to "Schedule 4" in the [Camera setup] tab to
display the setup window.
[Setup via recorder's main monitor]
57
To Next Page
Loading...
Need help?
General
