6.2 How to change parameters
6-2
6. Parameters
6.2 How to change parameters
A teaching pendant or PC software can be used to change parameters. This manual introduces
operating methods using a teaching pendant TB-02.
PC software operating method PC software manual (ME0155)
Teaching pendant operating method Teaching pendant manual (ME0355)
Data setter operation method Data setter manual (ME0375)
Edit parameters window
Touch Parameter edit on the Menu 1 screen.
The screen will switch to the Edit parameters
window.
If the TP operation mode is not Monitor mode,
a confirmation window will appear for
switching to Monitor mode.
Also, if the parameter edit password is set to a
value other than "0000", the password input screen will be displayed.
If the parameter edit password is set to a value other
than "0000", enter the password and press the [ENT]
key on the touch panel.
The Edit parameters window will open.
The parameter edit password is set to "0000" at shipping.
Refer to the Teaching pendant manual (ME0355) / Data setter manual
(ME0375) for information about changing the password.
1
Reference
Action
2
Reference
Action
To Next Page
Loading...
Need help?
General
