To Next Page

To Previous Page

Note: If you want to disable the fast increase/decrease function, press and hold

the down button, press and release the select button, and then release

the down button. The disabling of the fast increase/decrease function

lasts until cluster creation is completed or until the feature is again

enabled. If the up or down buttons are pressed and held while the

function is disabled, the value increases or decreases once every two

seconds. To again enable the fast increase/decrease function, press and

hold the up button, press and release the select button, and then release

the up button.

4. Press the right or left buttons to move to the number field that you want to

update.

5. Repeat steps 3 on page 147 and 4 for each number field that you want to

update.

6. Press the select button to complete the change.

Press

the right button to display the next secondary option or the left button to

display the previous options.

Subnet Mask

This option lets you display or change the subnet mask.

Attention: If you change the subnet mask address, ensure that you type the

correct address. Otherwise, you cannot access the cluster using the command line

tools or a Web browser.

Perform the following steps to change the subnet mask:

1. Press the select button. The first subnet mask number is displayed.

2. Press the up button if you want to increase the value that is displayed; press

the down button if you want to decrease that value. If you want to quickly

increase the highlighted value, hold the up button. If you want to quickly

decrease the highlighted value, hold the down button.