IBM Aptiva Reference Guide

64
Responding to error codes
1782
IDE Secondary Channel
Master
Drive Error
1
Make sure the IDE signal cable is properly connected
to the drive and to the system board.
2
Make sure the drive power cable is properly
connected.
3
Enter Setup and make sure that the IDE Secondary
Channel Master parameter is set to
Auto
. For
information on the Setup Utility options, see the
Aptiva online help.
4
If the error still shows after performing the above
steps, replace the IDE drive. It may be defective. For
more information on using the Setup Utility, see
“Using the Setup Utility” on page 71.
1783
IDE Secondary Channel
Slave
Drive Error
1
Make sure the IDE signal cable is properly connected
to the drive and to the system board.
2
Make sure the drive power cable is properly
connected.
3
Enter Setup and make sure that the IDE Secondary
Channel Slave parameter is set to
Auto
. For
information on the Setup Utility options, see the
Aptiva online help.
4
If the error still shows after performing the above
steps, replace the IDE drive. It may be defective. For
more information on using the Setup Utility, see
“Using the Setup Utility” on page 71.
1800
IRQ Setting Error
PnP ISA Card(s) Disabled
1
Enter Setup and set the Reset Resource Assignments
to
Yes
, then reboot the system.
2
If the error message reappears, determine which
onboard device is least necessary and disable it under
the Input/Output Ports menu in Setup.
For information on the Setup Utility options, see the
Aptiva online help.
Error code and description Here’s what to do...
If any of these problems continue after taking the actions
listed, run the diagnostics programs that came with your
computer. If you need service, see “HelpWare support and
services” on page 79.
66xarg.book : 66xach3.fm Page 64 Tuesday, June 30, 1998 10:18 AM

IBM Aptiva Specifications

General

Brand	IBM
Model	Aptiva
Category	Desktop
Language	English