IBM Aptiva Handbook

How Rapid Resume features affect your computer’s operation 29
System power light is
blinking, but system is
turned off.
Feature: Ring Indicator feature in
Wake Up on Ring
This is a normal activity of the
Ring Indicator feature in Wake Up
on Ring. The blinking light
indicates that Wake Up on Ring
turned on your computer to
receive data, a fax, or a voice
message.
Computer does not
automatically go into
Standby when
AutoPlay is enabled.
(In Windows 95, you
can turn on AutoPlay
for CDs. With
AutoPlay enabled,
audio CDs start to play
automatically when
you put them into the
CD-ROM drive.)
Feature: Standby
If AutoPlay is enabled, your
computer may not enter Standby
unless you disable hard drive and
CD-ROM drive checking in the
Setup Utility. For information
about these Setup Utility options,
see “Rapid Resume advanced
options” on page 43.
Table 1: Rapid Resume features activity
Activity: Feature and explanation:
Computer won’t start
from diskette if Rapid
Resume is enabled.
Feature: Rapid Resume
After you turn on the computer,
press Ctrl + Alt + Delete when
you see the Rapid Resume screen.
There may be a slight delay before
the computer restarts.
Note that using Ctrl + Alt +
Delete will cause the loss of your
saved desktop. If possible, first
start your computer without the
diskette and save any unsaved
information. Then shut down your
computer and restart in MS-DOS
mode. From DOS, insert the
diskette and press Ctrl + Alt +
Delete.
Table 1: Rapid Resume features activity
Activity: Feature and explanation:

IBM Aptiva Specifications

General

Brand	IBM
Model	Aptiva
Category	Desktop
Language	English