L-
17 After approximately
20
minutes, the
9401
System Unit IPL should
be
complete {IPL times may vary
depending
on
the AS/400 applications).
Is
the following shown
on
the Function/Data display located
on
the control panel?
01
B N
Yes
No
i Perform
an
IPL
on
the system again (see Chapter
6,
"Perform
an
Initial Program
Load"
on
page
6-1
).
If
the system does not complete the IPL successfully, contact
your service representative.
18 Prepare
to
update the
PCS
directory
on
the personal computer.
Reboot the personal computer by performing the following steps:
• Use the power switch to power off the personal computer.
Wait at least ten seconds. Power
on
the personal computer again.
Enter a user
ID
when prompted (for example, QSECOFR). When the password prompt appears,
enter the correct password or press the Enter key.
19 Press the
F1
key to display the
'files
that need to
be
updated.
Do
you
want
to
update the PCS directory
on
the personal computer?
Yes
No
Press the Esc key and go
to
step
21
of this procedure.
20
To
update the PCS directory, the Client Access/400 files are transferred to the personal computer.
When the transfer
is
complete, reboot the personal computer by performing the following:
• Press and hold the Alt and Ctrl keys, then press the
Del
key.
Enter a user
ID
when prompted (for example, QSECOFR). When the password prompt appears,
press the Enter key.
21
Are
you
installing Client Access/400 with Microsoft Windows?
Yes
No
You
have completed the installation of Client Access/400 with DOS.
This ends the procedure.
22
Is
Microsoft Windows active?
No
Yes
i To exit the Microsoft Windows program, press and hold the Alt key, then press the
F4
key. At the Exit Windows box, press the Enter key.
Continue to the next step of this procedure.
Chapter
6.
Perform
an
Initial Program
Load
6-9
To Next Page
Loading...
