IBM AS/400 9401 P03 - Page 52

23 Configure Client Access/400 to run with Microsoft Windows by performing the following procedure:
a. At the DOS prompt. type the following and press the Enter key:
I:
b. At the DOS prompt, type the following and press the Enter key:
CD\QIWSFL2
c. At the DOS prompt, type the following and press the Enter key:
CFGPCS
d. At the Client Access/400 display press the Enter key.
e. The Client Access/400 Configuration display appears. Press the G key to select General
options.
f. Type the drive letter (C) that contains the Client Access/400 directory and press the Enter key.
g. The General Options for Client Access/400 display appears. Press the W key to select Micro-
soft Windows and DOS 5. 0. option.
h. Use the following recommended information to configure Client Access/400 with Microsoft . · ~
Windows. ~
Notes:
a. Use the Tab key to move the cursor from one field to the next.
b. Use one of the following methods to select the action:
• Type the action.
• Move the cursor to your selection and press the space bar.
• Type the highlighted letter.
• Type the selection number.
After all of the actions are selected, press the Enter key.
c. Some of the fields may not appear.
Field Action
Run Client Access with Microsoft Windows
Yes
AS/400 connection environment
Microsoft Windows
Create Client Access/400 group
Yes
Directory where Microsoft Windows is located y:\xxxxxxxx
Run Client Access with DOS 5.0 Task Swapper No
Communications buffer size
16
Options to use Work Station Function
none selected
Notes:
xxxxxxxx is the directory where Microsoft Windows is located (usually, WINDOWS).
2 y is the drive letter where Microsoft Windows is located (usually, C).
At the Confirmation window, press the Enter key to continue.
Type 1 to save and exit the installation program.
6-10 AS/400 9401 Insta ll ation - Models P03 and 1 OS V3R1