IBM Aspera HST

| Asconfigurator Reference | 316
Setting or getting user/group data requires you to specify the username or group name as the first parameter of the
asconfigurator command.
Note: Not all available parameters are listed below, only the most commonly used. To view a complete list, run the
following command:
# /opt/aspera/bin/asuserdata -+
Transfer Authorizations
absolute
The docroot path of a user.
Values: (String)
authorization_transfer_in_value
Incoming transfer authorization. The token value only allows transfers initiated with valid tokens.
Values: allow (default), deny, token
authorization_transfer_out_value
Outgoing transfer authorization. The token value only allows transfers initiated with valid tokens.
Values: allow (default), deny, token
authorization_transfer_in_external_provider_url
The URL of the external authorization provider for incoming transfers.
Values: (String)
authorization_transfer_out_external_provider_url
The URL of the external authorization provider for outgoing transfers.
Values: (String)
authorization_transfer_in_external_provider_soap_action
The SOAP action required by the external authorization provider for incoming transfers.
Values: (String)
authorization_transfer_out_external_provider_soap_action
The SOAP action required by the external authorization provider for outgoing transfers.
Values: (String)
token_encryption_type
The cipher used to generate encrypted authorization tokens.
Values: aes-128 (default), aes-192, aes-256
token_encryption_key
The secret passphrase used to generate encrypted authorization tokens. Use instead of
token_encryption_keyfile.
Values: (String)
token_life_seconds
The length of time a token is valid in seconds. The default value is 86400 seconds (24 hours).
Values: (Number)
Transfer Bandwidth Policies
transfer_in_bandwidth_aggregate_trunk_id
The ID of the Vlink to apply to incoming transfers. A value of 0 disables the Vlink.