Chapter 7. Parts listing, DS3500 storage subsystem and
EXP3500 expansion enclosure
The replaceable components that are available for the DS3500 storage subsystem
and EXP3500 expansion enclosure are described in this chapter. To check for an
updated parts listing on the Web, complete the following steps:
1. Go to http://www.ibm.com/servers/storage/support/.
2. On the “Support for System Storage and TotalStorage products” page, under
Select your product,intheProduct family field, select Disk systems.
3. In the Product field, select IBM System Storage DS3500.
4. Click Go.
5. For documentation updates, click the Install/Use tab.
Replaceable components
Replaceable components are of three types:
v Tier 1 customer replaceable unit (CRU): Replacement of Tier 1 CRUs is your
responsibility. If IBM installs a Tier 1 CRU at your request, you will be charged for
the installation.
v Tier 2 customer replaceable unit: You may install a Tier 2 CRU yourself or
request IBM to install it, at no additional charge, under the type of warranty
service that is designated for your server.
v Field replaceable unit (FRU): FRUs must be installed only by trained service
technicians.
For information about the terms of the warranty and getting service and assistance,
see the Warranty Information document that comes with the storage subsystem and
expansion enclosure.
DS3512 storage subsystem and EXP3512 expansion enclosure parts
listing
Figure 101 on page 136 and the following table provide a parts listing for the
DS3512 storage subsystem and EXP3512 expansion enclosure.
© Copyright IBM Corp. 2010 135