IBM Storwize V7000 Unified Series User Manual

8. See Figure 11 on page 64 for an example of a Self-Monitoring, Analysis and
Reporting Technology (SMART) error found for a hard drive. SMART adds
monitoring and troubleshooting functionality by automatically checking a disk
drive's health and reporting potential problems. If any SMART errors are
detected for a hard drive, you can see the status in the section for Error
Information as shown in Figure 11 on page 64.
Note: In Figure 11 on page 64 the hard disk drive with Target ID #6 has a
ASC/ ASCQ error of 05/00.
For isolation and the repair of hard disk problems, refer to “Troubleshooting
the System x3650” in the IBM Storwize V7000 Unified Information Center.
For a list of SMART (ASC/ASCQ) error codes and their descriptions, go to
“SMART ASC/ASCQ error codes and messages” on page 64.
Mirror Information:
NOTICE: The mirror is not created/configured. <---
Drive Information:
Total number of drives found: 2
Target on ID #4
Device is a Hard disk
Enclosure # : 1
Slot # : 1
Connector ID : 1
Target ID : 4
State : Ready (RDY)
Size (in MB)/(in sectors) : 286102/585937500
Manufacturer : IBM-ESXS
Model Number : XXXXXXXXXXXX
Firmware Revision : XXXX
Serial No : XXXXXXXXXXXXXXXXXXXX
Drive Type : SAS
Protocol : SAS
Error Information
SMART Error Count : none
SMART ASC : none
SMART ASCQ : none
Target on ID #6
Device is a Hard disk
Enclosure # : 1
Slot # : 0
Connector ID : 0
Target ID : 6
State : Ready (RDY)
Size (in MB)/(in sectors) : 286102/585937500
Manufacturer : IBM-ESXS
Model Number : XXXXXXXXXXXX
Firmware Revision : XXXX
Serial No : XXXXXXXXXXXXXXXXXXXX
Drive Type : SAS
Protocol : SAS
Error Information
SMART Error Count : none
SMART ASC : none
SMART ASCQ : none
Figure 10. Example that shows that the mirror is not created
Chapter 4. File module 63

IBM Storwize V7000 Unified Series Specifications

General

Brand	IBM
Model	Storwize V7000 Unified Series
Category	Storage
Language	English