gw_6
(Optional) The IPv6 gateway for Ethernet port 1 on the system.
prefix_6
(Optional) The IPv6 prefix for Ethernet port 1 on the system.
name
(Optional) The name of the new system.
Description
This command creates a storage system.
This command calls the satask mkcluster command.
Query status command:
Use this command to determine the current service state of the node canister.
Syntax
sainfo getstatus
Parameters
None.
Description
This command writes the output from each node canister to the USB key.
This command calls the sainfo lsservicenodes command, the sainfo
lsservicestatus command, and the sainfo lsservicerecommendation command.
Event reporting
Events that are detected are saved in an event log. As soon as an entry is made in
this event log, the condition is analyzed. If any service activity is required, a
notification is sent.
Event reporting process
The following methods are used to notify you and the IBM Support Center of a
new event:
v If you enabled Simple Network Management Protocol (SNMP), an SNMP trap is
sent to an SNMP manager that is configured by the customer.
v If enabled, log messages can be forwarded from a sender to a receiver on an IP
network by using the syslog protocol.
v If enabled, event notifications can be forwarded from a sender to a receiver
through Call Home email.
v If Call Home is enabled, critical faults generate a problem management record
(PMR) that is sent directly to the appropriate IBM Support Center.
Chapter 5. Control enclosure 181
|
|
To Next Page
Loading...
Need help?
General