Power cords for Models L32 and D32
This section describes the power cords used with models L32 and D32 of the
TS3500 Tape Library.
The appropriate power cord for the TS3500 Tape Library is attached at the factory
(based on the destination code of your country or region). Chicago, Illinois (U.S.A.)
requires a 1.8 m (6 ft) power cord (feature code 9986). Power cords used in the
United States and Canada are listed by the Underwriter's Laboratories and certified
by the Canadian Standards Association. Table 47 on page 125 lists the 200–240 V ac
power cords and Table 48 on page 126 lists the 100–127 V ac power cords to use
with the library. (The term “power cord” refers to the cable that connects the
library to the receptacle.) Refer to Figure 29 on page 126 and match the number
that is beside each receptacle to the receptacle number listed in the tables.
Be aware that each frame that contains a frame control assembly (FCA)
is protected by a main line circuit protector in the FCA. Each FCA must
be further protected by a circuit breaker of the proper rating at the
service rail (customer outlet).
124 IBM System Storage TS3500 Tape Library with ALMS: Introduction and Planning Guide
To Next Page
Loading...
Need help?
General